Malco® HCAD

Works well with HC1 and HC2 Hole Cutters. May be used to help cut take-off holes in sheet metal ductwork suspended below floor joists or for take-offs from the side of large trunk lines where reaching up and cutting at 90 deg is desirable.

Malco® Angle Drive Accessory, For Use With: 1/4 and 3/8 in Electric Drills

• 1:1 gear ratio
• Comes with own chuck
• Fits 1/4 and 3/8 in electric drills

• Malco CT425 Warranty https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Malco_CT425_Warranty.pdf
• Malco KBHC Catalog https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Malco_KBHC_Catalog.pdf
• Malco Products HCAD Manual https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Malco_Products_HCAD_Manual.pdf