| Diameter - Thread Size | : | #10 |
| Drive Type | : | Slotted |
| Finish | : | Zinc Plated |
| Head Size | : | 1/4 in |
| Head Type | : | Hex Washer |
| Overall Length | : | 3 in |
| Point Type | : | Tapered |
| Thread Length | : | 1 in |
| Thread Type | : | Double |
| Type | : | Self-Piercing |
A unique thread design and quality controlled manufacture spell the Zip-In difference. Zip-In's sophisticated heat treat process allows the screw to taper to a fine, sharp point without sacrificing critical point strength. A single starting thread is formed down to the very tip of the point and is the source of Zip-In's penetrating power. A second thread above the point engages after initial penetration and drills in the screw double fast. Zip-In screws are faster driving, with a greater capacity for fastening heavier gas of sheet metal than any other self-piercing type.
Malco® Zip-In® Sheet Metal Screw, Self-Piercing, #10 Thread, 3 in Overall Length, Hex Washer Head, Slotted Drive, Zinc Plated, Tapered Point, 1/4 in Head, Double Thread, 1 in Thread Length
- Undercut - indented hex washer slotted head
- Bright zinc plated
- Burr free
- One 1/4 in hex driver accommodates all sizes
- Undercut - always seats flush
- Trademarked and patented head markings indicate one and only genuine Zip-In®
- Combination lead double thread design
- Single starting thread machined down to very tip of screw point
- Instantly penetrates and engages in heavy gauge sheet metal and layered light gauge
- Consistent hard point
- Quality controlled heat treat
- Sharp tapered point will not mushroom or break
- No walking